User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 74 of 296
Aug 10, 2012
5.1.2 [Synchronization session] List Box
In the [Synchronization session] list box, set the condition for the synchronization session.
Lists that can be set are shown below.
[Debugger ID] This setting is for a unique ID that can specify the debugging
session. Ensure that the setting is capable of doing so.
*1
[Status] Display the state of the session.
Not open: The session is not open in the High-performance
Embedded Workshop. The session is opened when the
[Synchronize] button is clicked.
Not connected: The session is not connected to the emulator.
Break: The session is connected to the emulator. The user
program is in break state.
Running: The session is connected to the emulator. The user
program is being executed.
[Options] When a synchronized debugging session is started, this setting
specifies how the session is to be handled.
Debug: The session is to be used for debugging.
Freerun: The session is not to be used for debugging. The
operation of the CPU core is the same as if the emulator were
not connected.
[Type] Display the type of target platform for the session.
*2
Single core: Platform with a single core.
Multi-core: Platform with multiple cores.
[Workspace] Display the name of the absolute pass file for workspace file
including the session.
[Session] Display the name of session in the workspace.
Note: 1. Do not mix up session names for different devices.
2. Do not mix up sessions for single-core and multi-core platforms.