User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 4 Preparations for Debugging
R20UT0363EJ0500 Rev. 5.00 Page 71 of 296
Aug 10, 2012
In the list box that is circled in figure 4.21, select the session file name including the character
string that has been set in the [Target name] text box in figure 4.9, [New Project –8/9– Setting the
Debugger Options] dialog box. The setting for using the emulator has been registered in this
session file.
After the session file name is selected, the emulator will automatically be connected. For details
on the session file, refer to section 4.4, Debug Sessions.
4.6 Reconnecting the Emulator
When the emulator is disconnected, use the following way for reconnection:
Select [Debug -> Connect] or click the [Connect] toolbar button (
). The emulator is connected.
Note: 1. The emulator must be selected in the [Target] drop-down list box of the [Debug
Settings] dialog box (see figure 4.16, [Debug Settings] Dialog Box ([Target] Page))
that is opened by selecting [Debug settings] from the [Debug] menu.
2. If reconnection is to proceed during synchronized debugging, disconnect all of the
cores before reconnecting the emulator.