User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 4 Preparations for Debugging
R20UT0363EJ0500 Rev. 5.00 Page 55 of 296
Aug 10, 2012
4. Set the configuration file name. The configuration file saves the state of High-performance
Embedded Workshop except for the emulator.
Selects the CPU core numbers for debugging from the [Core] drop-down list box.
Figure 4.9 [New Project –8/9– Setting the Debugger Options] Dialog Box
This is the end of the emulator setting.
Exit the Project Generator according to the instructions on the screen. The High-performance
Embedded Workshop is activated.
5. After the High-performance Embedded Workshop has been activated, connect the emulator.
However, it is not needed to connect the emulator immediately after the High-performance
Embedded Workshop has been activated.
To connect the emulator, use one of the methods (a) and (b) below. For operation during
connection, refer to section 3.9, System Check.