User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 43 of 296
Aug 10, 2012
14. Input the reset signal from the user system, and click the [OK] button.
15. If no reset signal is detected, the following dialog box is displayed.
Figure 3.24 [Can not find /RESET signal] Dialog Box
16. If the "Connected" is displayed in the [Output] window of the High-performance Embedded
Workshop for CPU0, starting up the emulator is completed.
Figure 3.25 [Output] Window
Notes: 1 If the emulator is not initiated, the following dialog boxes shown in figures 3.26
through 3.32 will be displayed.
(a) If the following dialog box is displayed and the method 12 above is unavailable, the
power of the user system may not be input or the RESET signal may not be input to
the device. Check the input circuits for the power of the user system and the reset pin.