User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 42 of 296
Aug 10, 2012
Figure 3.21 Dialog Box to Confirm Updating of the SHxxxx Emulator Firmware
CAUTION
The USB cable must not be disconnected until writing is
complete.Early disconnection may damage the emulator.
10. When the Reset assert (Auto Connect) option is in use, the dialog box shown in figure 3.22
is displayed. When the power of the user system is turned on, figure 3.22 is not displayed.
Figure 3.22 Dialog Box of the Turn the Power On Message
11. Power on the user system.
12. The dialog box shown in figure 3.23 is displayed.
Figure 3.23 Dialog Box of the RESET Signal Input Request Message
13. Power on the user system.