User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 40 of 296
Aug 10, 2012
7. The [Select Emulator mode] dialog box is displayed and indicates the device group to be
used.
Figure 3.18 [Select Emulator mode] Dialog Box
The [Select Emulator mode] dialog box has the following options.
 [Reset assert (Auto Connect)] check box
A reset signal is generated by the emulator, and steps 12 and 14 are skipped.
CAUTION
Do not to use the [Reset assert (Auto Connect)] option unless the
port connector is properly connected as shown in Section 1.5,
Recommended Circuit between the H-UDI Port Connector and the
MPU of the additional document, Supplementary Information on
Using the SHxxxx. Using the [Auto connect] option without the
proper connection will damage the user system.
Select the device name in use from the [Device] drop-down list box and click on OK.