User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 39 of 296
Aug 10, 2012
6. The [CPU Select] dialog box or [Select Emulator mode] dialog box is displayed.
Figure 3.17 [CPU Select] Dialog Box
The [CPU Select] dialog box has the following options.
 [Search the best JTAG clock] check box
Selects finding of the fastest usable JTAG clock value, and starting up with this as the initial
value.
 [Reset assert (Auto Connect)] check box
A reset signal is generated by the emulator, and steps 12 and 14 are skipped.
If the [Reset assert (Auto Connect)] option is in use, turn on the power to the user system at
this stage.
CAUTION
Do not to use the [Reset assert (Auto Connect)] option unless the
port connector is properly connected as shown in Section 1.5,
Recommended Circuit between the H-UDI Port Connector and the
MPU of the additional document, Supplementary Information on
Using the SHxxxx. Using the [Auto connect] option without the
proper connection will damage the user system.
Select the device name in use from the [CPU Select] drop-down list box and click on OK.