User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 30 of 296
Aug 10, 2012
(1) The connector must be installed to the user system. Table 3.2 shows the recommended
connector for the emulator.
Table 3.2 Recommended H-UDI Port Connector
Connector Type Number Manufacturer Specifications
14-pin connector 2514-6002 Minnesota Mining &
Manufacturing Ltd.
14-pin straight type
38-pin connector 2-5767004-2 Tyco Electronics Corporation 38-pin Mictor connector
Notes: 1. When designing the 14-pin connector layout on the user board, do not place any
components within 3 mm of the H-UDI port connector.
When designing the 36-pin connector layout on the user board, do not connect other
signal lines to the H-UDI port connector.
2. The H-UDI is an interface compatible with the Joint Test Action Group (JTAG)
specifications.
(2) The pin assignments of the connector are shown in section 2, in the additional document,
Supplementary Information on Using the SHxxxx.
(3) Connect pins 5 and GND bus read located in the center of the H-UDI port connector (when
using the 38-pin user system interface cable) and pins 9, 10, 12, 13, and 14 (when using the 14-
pin user system interface cable) of the H-UDI port connector to GND firmly on the PCB.
These pins are used as electrical GND and to monitor the connection of the H-UDI port
connector. Note the pin assignments of the H-UDI port connector.