Manualshelf

User`s manual

ManualsBrandsRenesas ManualsNetwork CardSuperH Family E10A-USB
41424344454647484950
SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 29 of 296
Aug 10, 2012
3.6 Connecting the Emulator to the User System
Use the procedure below to connect the emulator to the user system with the user system interface
cable, or to disconnect them when moving the emulator or the user system.
1. Check that the host computer is turned off or the emulator is not connected to the host
computer with the USB cable.
2. Connect the user system interface cable to the user-side connector of the emulator.
3. Connect the USB cable to the host-side connector of the emulator.
Figure 3.8 shows the position of the connector.
User interface cable connector
Figure 3.8 Position of the Connector