User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 27 of 296
Aug 10, 2012
3.5 Connecting the Emulator to the Host Computer
This section describes how to connect the emulator to the host computer. For the position of each
connector of the emulator, refer to section 3.2, Emulator Hardware Configuration.
Notes: 1. When the [Add New Hardware] wizard is displayed, select the [Search for the best
driver for your device. (Recommended)] radio button.
2. Be sure to install the software for the emulator before putting the emulator in place.
WARNING
Always switch OFF the emulator product and the user
system before connecting or disconnecting any CABLES
except for the USB interface cable. Failure to do so will result
in a FIRE HAZARD and will damage the user system and the
emulator product or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.