User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 3 Preparation before Use
R20UT0363EJ0500 Rev. 5.00 Page 24 of 296
Aug 10, 2012
(e) Core switch LED: Marked ‘3’. When this LED is lit, the E10A-USB switches the micro
computer to be controlled.
(f) UVCC LED: Marked ‘4’. When this LED is lit, the E10A-USB is supplied the
UVCC .
(g) Host connector: Marked ‘
’. A connector for the host computer is provided at the
side of this mark.
(h) User connector: Marked ‘USER I/F’. A connector for the user system interface cable is
provided at the side of this mark.
Note: Even if the LED is not lit, the USB is not disconnected or malfunctioned.
Emulator Host-side View:
Figure 3.4 Emulator Host-side View
(a) Host-side connector: A USB connector for the host computer. Be sure to connect the
provided USB cable.
Emulator User-side View:
Figure 3.5 Emulator User-side View