User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 7 Tutorial SH-4A
R20UT0363EJ0500 Rev. 5.00 Page 247 of 296
Aug 10, 2012
 Click the [OK] button.
 The first point display in the State line changes from Disable to Enable.
 The first point display in the Condition line changes from None to Address =
H’0000108C (tutorial.cpp/45).
 The first point display in the Action line displays as Break).
 Set the program counter and stack pointer values (CPU0: PC = H’00000800, R15 = H'00010000
and CPU1: PC = H’00100800, R15 = H'00110000) that were set in section 7.9, Setting
Registers, in the [Register] window of the High-performance Embedded Workshops for CPU0
and CPU1. Click on the [Go] button of the High-performance Embedded Workshop for either
CPU0 or CPU1.
The internal RAM area differs depending on the MCU. Refer to the hardware manual of the
MCU used.
 If program execution is failed, reset the device and execute again the procedures above.
The program runs and then stops at the condition specified as Break Condition 1.