User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 6 Tutorial SH-2A
R20UT0363EJ0500 Rev. 5.00 Page 184 of 296
Aug 10, 2012
 Click the [OK] button.
 The first point display in the State line changes from Disable to Enable.
 The first point display in the Condition line changes from None to Address =
H’00101050 (tutorial.cpp/45) pc Core Select CPU1 Break (CPU1).
Break (CPU1) is displayed for the first point in the Action line.
 Set the program counter and stack pointer values (PC = H’00000800 and R15 = H'FFF90000)
that were set in section 6.8, Setting Registers, in the [Register] window of the High-
performance Embedded Workshops for either CPU0 or CPU1. Click on the [Go] buttons of
both High-performance Embedded Workshops.
The internal RAM area differs depending on the MCU. Refer to the hardware manual of the
MCU used.
 If program execution is failed, reset the device and execute again the procedures above.
The program runs and then stops at the condition specified under Ch1 (IA_OA_DT_CT).