User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 6 Tutorial SH-2A
R20UT0363EJ0500 Rev. 5.00 Page 148 of 296
Aug 10, 2012
Figure 6.3 [Add Debugger] Dialog Box
Note: In case of failure to read the workspace, open the workspace and then read it, in accord with
the procedure described in section 3.9, System Check.
5. Click on the [Add] button again to open the [Add debugger] dialog box.
Check whether the workspace which was read previously to the [Workspace file] is
displayed. If this is not the case, read the workspace again by following the procedure 4,
above.
Selects CPU1 from the Project drop-down list box and then click on the OK button.
6. Set up the synchronized debugging state.
Select All debuggers synchronized under Synchronization style and check all of the
following check boxes under Synchronization options: Go, Break/Halt, and Step.
Select “Parallel” from the Synchronization debugging mode drop-down list.