User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 135 of 296
Aug 10, 2012
Note: Along with setting the address range, the start and end of the address range can be set in the
[From] and [To] options, respectively.
(3) [Data] page
Set a data condition.
Figure 5.36 [Trace Filter] Dialog Box ([Data] Page)
[Don't care]: Detects no data when this box is checked.
[Setting]: Detects the specified data.
[Point]: Specifies single data (not available when [Don’t care] has been checked).
[Range]: Specifies a data range (not available when [Don’t care] has been checked).
[From]: Enter single data or the minimum value of the data range (not available when
[Don’t care] has been checked).
[To]: Enter the maximum value of the data range (only available when [Range] has
been selected).
Note: Along with setting the data range, the minimum and maximum values can be set in the
[From] and [To] options, respectively.