User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 134 of 296
Aug 10, 2012
[Start PTR]: Enters a PTR value to start filtering.
[End PTR]: Enters a PTR value to end filtering.
Note: Along with setting the range for filtering, PTR values to start and end filtering can be set in
the [Start PTR] and [End PTR] options, respectively.
(2) [Address] page
Set an address condition.
Figure 5.35 [Trace Filter] Dialog Box ([Address] Page)
[Don't care]: Detects no address when this box is checked.
[Setting]: Detects the specified address.
[Point]: Specifies a single address (not available when [Don’t care] has been checked).
[Range]: Specifies an address range (not available when [Don’t care] has been checked).
[From]: Enter a single address or the start of the address range (not available when [Don’t
care] has been checked).
[To]: Enter a single address or the end of the address range (only available when
[Range] has been selected).