User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 133 of 296
Aug 10, 2012
Set filtering conditions and then press the [OK] button. This starts filtering according to the
conditions. Clicking the [Cancel] button closes the [Trace Filter] dialog box, which holds the
settings at the time when the dialog box was opened.
In filtering, only the trace information that satisfies one or more filtering conditions set in the above
pages will be displayed in the [Trace] window.
Filtering conditions can be changed several times to analyze data because the content of the trace
buffer is not changed by filtering.
(1) [General] page
Set the range for filtering.
Figure 5.34 [Trace Filter] Dialog Box ([General] Page)
[Don't care other pages]: Only selects the cycle number when this box is checked. Other options
become invalid.
[Enable Filter]: Enables the filter when this box is checked.
[Not designation]: Filters information that does not match the conditions set in those pages
when this box is checked.
[Trace display range]: Sets the range for filtering.