User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 123 of 296
Aug 10, 2012
[Channel A] [Bus state] : Sets a bus to acquire the window trace.
[M-Bus] : Select the M-Bus.
[DMAC] : Select the DMA.
[Channel B] Set the conditions to acquire the AUD trace.
[Read/Write] : Sets tracing of read or write access or both.
[Read] : Trace information is acquired
on reading.
[Write] : Trace information is acquired
on writing.
[Read/Write] : Trace information is acquired
on reading and writing.
[Start address] : Sets an address range for the tracing of data
access. The end address is set here.
[End address] : Sets an address range for the tracing of data
access. The end address is set here.
[Bus state] : Sets a bus to acquire the window trace.
[M-Bus] : Select the M-Bus.
[DMAC] : Select the DMA.