User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 117 of 296
Aug 10, 2012
This dialog box is used to specify conditions for the acquisition of trace information.
When [I-Trace] has been selected:
[I-Trace mode]: Set the bus and other conditions for acquisition of the internal trace.
[Channel 1] : Set the trace acquisition conditions for channel 1. The same conditions
cannot be set for channels 1 and 2.
[Type] [M-Bus & Branch, CPU0] : Trace information is acquired with M-bus
access and branching by CPU0 as
conditions.
[I-Bus, CPU0] : Trace information is acquired with I-bus
access by CPU0 as condition.
[F-Bus, CPU0] : Trace information is acquired with F-bus
access by CPU0 as a condition.
[M-Bus & Branch, CPU1] : Trace information is acquired with M-bus
access and branching by CPU1 as
conditions.
[I-Bus, CPU1] : Trace information is acquired with I-bus
access by CPU1 as a condition.
[F-Bus, CPU1] : Trace information is acquired with F-bus
access by CPU1 as a condition.
[DMAC] : Acquires trace information on access by
the DMAC.
[Channel 2] : Set the trace acquisition conditions for channel 2. The same conditions
cannot be set for channels 1 and 2.
[M-Bus & Branch, CPU0] : Trace information is acquired with M-bus
access and branching by CPU0 as
conditions.
[I-Bus, CPU0] : Trace information is acquired with I-bus
access by CPU0 as a condition.
[F-Bus, CPU0] : Trace information is acquired with F-bus
access by CPU0 as a condition.
[Type]
[M-Bus & Branch, CPU1] : Trace information is acquired with M-bus
access and branching by CPU1 as
conditions.
[I-Bus, CPU1] : Trace information is acquired with I-bus
access by CPU1 as a condition.