User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 110 of 296
Aug 10, 2012
Note: Since the displayed contents differ depending on the product, refer to each product’s online
help. Some supported chips do not have the AUD tracing function.
The following items may be displayed for some target devices for debugging.
Refer to the additional document Supplementary Information on Using the SHxxxx and the online
help for the specifications of the device.
Figure 5.22 [Trace] Window (Type 2)
[PTR] Pointer to lines within the trace buffer (the value for the last instruction to have been executed is
+ 0
[IP] The number of lines of acquired trace information
[Master] (Bus Master) The number of CPU which accessed the memory, or the type of bus master
[Type] Type of the trace information:
BRANCH: Branch source
DESTINATION: Branch destination
MEMORY: Memory access
S_TRACE: Executed Trace(x) function
LOST: Lost trace information (only in the realtime mode)
CPU-WAIT: CPU was waiting for the output of the trace information
(only in the non-realtime mode)
[Branch Type] Type of branch:
GENERAL: General branch
SUBROUTINE: Subroutine branch
EXCEPTION: Exceptional branch
[Bus] Indicates the bus over which access proceeded
[R/W] Indicates whether access to data was reading or writing
[Address] Address