User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 105 of 296
Aug 10, 2012
5.6.20 Sequential Conditions
Sets the sequential condition of the channel.
5.6.21 Editing Event Conditions
Handlings for settings other than PC breakpoints and event conditions are common. The following
describes examples of such handling.
5.6.22 Modifying Event Conditions
To modify an event condition, select an event condition to be modified, and choose [Edit...] from
the popup menu to open the dialog box for the event, which allows the user to modify the event
conditions. The [Edit...] menu is only available when one event condition is selected.
5.6.23 Enabling Event Conditions
Select an event condition and choose [Enable] from the popup menu to enable the selected event
condition.
5.6.24 Disabling Event Conditions
Select an event condition and choose [Disable] from the popup menu to disable the selected event
condition. When an event condition is disabled, the event condition will remain in the list, but an
event will not occur when the specified conditions have been satisfied.
5.6.25 Deleting Event Conditions
Select an event condition and choose [Delete] from the popup menu to remove the selected event
condition. To retain the event condition but not have it cause an event when its conditions are met,
use the [Disable] option (see section 5.6.24, Disabling Event Conditions).
5.6.26 Deleting All Event Conditions
Choose [Delete All] from the popup menu to remove all event conditions.