User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 104 of 296
Aug 10, 2012
PAn_Start_Point: Measurement on performance analysis channel n starts.
PAn_End_Point: Measurement on performance analysis channel n ends.
When a channel is double-clicked in this window, the [Event condition] dialog box is opened and
the conditions can be modified. For details on the [Event condition] dialog box, refer to the on-line
help for each product.
A popup menu containing the following options is available by right-clicking within the window.
5.6.14 Edit...
Only enabled when one channel is selected. Select an event to be edited and click this item. The
[Event condition] dialog box will open and conditions can be changed.
5.6.15 Enable
Enables the selected channel(s). A channel that the condition has not been set is not enabled.
5.6.16 Disable
Disables the selected channel(s). When a channel is disabled, the [Action] will not occur even if
specified conditions have been satisfied.
5.6.17 Delete
Initializes the condition of the selected channel. To retain the details of the channel but not have it
cause the [Action] when its conditions are met, use the Disable option (see section 5.5.16, Disable).
5.6.18 Delete All
Initializes conditions of all channels.
5.6.19 Go to Source
Only enabled when one channel is selected. Opens the [Source] window at address of channel.
If an address value has not been set to the channel, this option cannot be used.