User`s manual

SuperH Family E10A-USB Emulator for Multi-core Microcomputers Section 5 Debugging
R20UT0363EJ0500 Rev. 5.00 Page 103 of 296
Aug 10, 2012
When [Value] is selected, if an overloaded function or class name including a member function is
specified in address, the [Select Function] dialog box opens.
Clicking the [OK] button sets the break conditions. Clicking the [Cancel] button closes this dialog
box without setting the break conditions.
5.6.13 Setting Event Conditions
On the [Event condition] sheet, the settings for event conditions are displayed, modified, and added.
Figure 5.19 [Event] Window ([Event condition] Sheet)
This window displays and sets the event condition. Since the number of channels for detecting
conditions and the contents to be set differ depending on the product, refer to the on-line help for
each product.
Items that can be displayed in the sheet are listed below.
[Type] Indicates the channel number
[State] Whether the channel is enabled or disabled
Enable: Valid
Disable: Invalid
[Condition] Displays the set conditions. The displayed contents differ depending on the channel.
[Action] Operation of the emulator when a condition is satisfied.
Break: A break in program execution
Trace: Trace information is acquired.
Sequential: The event occurs when the channel conditions are matched in the
given sequence.