User`s manual

SuperH™ Family E10A-USB Emulator Section 2 Software Specifications when Using the Emulator
R20UT2188EJ0100 Rev. 1.00 Page 21 of 24
Aug 09, 2012
2.2.6 Performance Measurement Function
The emulator supports the performance measurement function.
(1) Setting the Performance Measurement Conditions
To set the performance measurement conditions, use the [Performance Analysis] dialog box and
the PERFORMANCE_SET command. When any line in the [Performance Analysis] window is
clicked with the right mouse button, a popup menu is displayed and the [Performance Analysis]
dialog box can be displayed by selecting [Setting].
Note: For the command line syntax, refer to the online help.
(a) Specifying the Measurement Start/End Conditions
The measurement start/end conditions are specified by using Event Condition 1,2. The [Ch1,2,3]
list box of the [Combination action (Sequential or PtoP)] dialog box can be used.
Table 2.12 Measurement Period
Classification Item Description
Selection in
the [Ch1, 2, 3]
list box
Ch2 to Ch1
PA
The period from the satisfaction of the condition set in Event
Condition 2 (start condition) to the satisfaction of the condition set
in Event Condition 1 (end condition) is set as the performance
measurement period.
Ch1 to Ch2
PA
The period from the satisfaction of the condition set in Event
Condition 1 (start condition) to the satisfaction of the condition set
in Event Condition 2 (end condition) is set as the performance
measurement period.
Other than
above
The period from the start of execution of the user program to the
occurrence of a break is measured.
Figure 2.3 [Performance Analysis] Dialog Box