User`s manual

SuperH™ Family E10A-USB Emulator Section 2 Software Specifications when Using the Emulator
R20UT2188EJ0100 Rev. 1.00 Page 12 of 24
Aug 09, 2012
(1) Sequential Setting
Using the [Combination action (Sequential or PtoP)] dialog box specifies the sequential condition
and the start or end of performance measurement.
Table 2.7 Conditions to Be Set
Classification Item Description
[Ch1, 2, 3] list box Sets the sequential condition and the start or end of performance
measurement using Event Conditions 1 to 3 and 11.
Don’t care Sets no sequential condition or the start or end of
performance measurement.
Break: Ch3-2-1 Break in execution when Event Conditions 3, 2,
and 1 are satisfied in that order.
Break: Ch3-2-1,
Reset point
Break in execution when Event Conditions 3, 2,
and 1 are satisfied in that order.
Enables the reset point of Event Condition 11.
Break: Ch2-1 Break in execution when Event Conditions 2 and 1
are satisfied in that order.
Break: Ch2-1,
Reset point
Break in execution when Event Conditions 2 and 1
are satisfied in that order.
Enables the reset point.
I-Trace stop: Ch3-2-1 Halts acquisition of an internal trace when Event
Conditions 3, 2, and 1 are satisfied in that order.
I-Trace stop: Ch3-2-1,
Reset point
Halts acquisition of an internal trace when Event
Conditions 3, 2, and 1 are satisfied in that order.
Enables the reset point.
I-Trace stop: Ch2-1 Halts acquisition of an internal trace when Event
Conditions 2 and 1 are satisfied in that order.
I-Trace stop: Ch2-1,
Reset point
Halts acquisition of an internal trace when Event
Conditions 2 and 1 are satisfied in that order.
Enables the reset point.
Ch2 to Ch1 PA Sets the performance measurement period during
the time from the satisfaction of the condition set in
Event Condition 2 (start condition) to the
satisfaction of the condition set in Event Condition
1 (end condition).