User`s manual

SuperH Family E10A-USB Emulator Section 4 Preparations for Debugging
R20UT0870EJ1000 Rev. 10.00 Page 79 of 292
Aug 10, 2012
2. The Project Generator is started.
If you have purchased the toolchain, the following dialog box is displayed.
Figure 4.7 [New Project Workspace] Dialog Box
[Workspace Name] edit box: Enter the new workspace name. Here, for example, enter
‘test’.
[Project Name] edit box: Enter the project name. When the project name is the
same as the workspace name, it needs not be entered.
[CPU family] drop-down list box: Select the target CPU family.
[Tool chain] drop-down list box: Select the target toolchain name when using the toolchain.
Otherwise, select [None].
[Project type] list box: Select the project type to be used.
Note: When [Demonstration] is selected in the emulator, note the following:
The [Demonstration] is a program for the simulator. When the generated program is used
by the emulator, delete the Printf statement.