User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 69 of 292
Aug 10, 2012
(f) The following dialog box is displayed when the flash memory cannot be erased.
Change the MCU since the flash memory has been reprogrammed more times than the
limitation.
Figure 3.57 [Flash memory erase error!] Dialog Box
Note: If a mode is illegally set, the error message shown in figure 3.57 will be displayed.
(g) The following dialog box is displayed when the flash memory cannot be
reprogrammed. An incorrect system clock value has been input to the [Clock] dialog
box or the flash memory has been reprogrammed more times than the limitation.
Figure 3.58 [Error sending Flash memory write program] Dialog Box