User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 66 of 292
Aug 10, 2012
Notes: 1. If the emulator is not initiated, the following dialog boxes shown in figures 3.50
through 3.56 will be displayed.
(a) If the following dialog box is displayed and the method 11 above is unavailable, the
power of the user system may not be input or the RESET signal may not be input to
the device. Check the input circuits for the power of the user system and the reset pin.
Figure 3.50 [Can not find /RESET signal] Dialog Box
(b) If the following dialog box is displayed, check that the H-UDI port connector on the
user system is correctly connected.
Figure 3.51 [Check the connection] Dialog Box