User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 64 of 292
Aug 10, 2012
13. If no reset signal is detected, the following dialog box is displayed.
Figure 3.46 [Can not find /RESET signal] Dialog Box
When the [Ignore] button is clicked, the emulator issues a reset in the CPU for initiation.
However, this method is unavailable for some products. For details, refer to section 2.2,
Specific Functions for the Emulator when Using the SHxxxx, in the additional document,
Supplementary Information on Using the SHxxxx.
14. When using the MCU with flash memory, the [Clock] dialog box shown in figure 3.47 is
opened.
For the [Clock] dialog box, set the frequency of the crystal oscillator which has been connected
to or the external clock which has been input to the target microcomputer (MCU).
Figure 3.47 [Clock] Dialog Box