User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 63 of 292
Aug 10, 2012
Figure 3.44 Dialog Box to Confirm Updating of the SHxxxx Emulator Firmware
CAUTION
The USB cable must not be disconnected until writing is
complete. Early disconnection may damage the emulator.
Note: The above dialog boxes are only displayed if you are using the HS0005KCU01H (serial
No.: 03311C or later) or HS0005KCU02H (serial No.: 04146E or later) emulator
hardware. In this case, follow the procedure described in section 3.10.1, Setting up at
Purchasing the Emulator or Updating the Version of Software.
10. The dialog box shown in figure 3.45 is displayed.
Figure 3.45 Dialog Box of the RESET Signal Input Request Message
11. Power on the user system.
12. Input the reset signal from the user system, and click the [OK] button.