User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 61 of 292
Aug 10, 2012
7. The [Select Emulator mode] dialog box is displayed depending on the MCU/MPU used.
Figure 3.41 [Select Emulator mode] Dialog Box
Select the MCU/MPU name in use from the [Device] drop-down list box. The following items are
selectable in the [Mode] group box.
 E10A-USB Emulator
The E10A-USB emulator for the specified MCU/MPU is activated. Debugging the
program is enabled.
 Writing Flash memory
The user program is programmed to the internal flash memory. To download a load
module, register it in the workspace. Do not attempt anything other than downloading of
the load module.