User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 58 of 292
Aug 10, 2012
3.11 System Check
When the software is executed, use the procedure below to check that the emulator is connected
correctly. Here, use the workspace for a tutorial provided on the product.
Refer to section 4, Preparations for Debugging, for the other activating method to create a new
project or use an existing workspace.
1. Connect the emulator to the host computer.
2. Connect the user system interface cable to the connector of the emulator.
3. Connect the user system interface cable to the connector in the user system.
4. Select [Renesas] -> [High-performance Embedded Workshop] -> [High-performance
Embedded Workshop] from [Programs] in the [Start] menu.
Figure 3.37 [Start] Menu
Note: The [High-performance Embedded Workshop] -> [Tools] is not displayed depending on
the user’s environment.