User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 55 of 292
Aug 10, 2012
Notes: 1. If the version numbers shown in (b) and (c) are the same, setup of the emulator is not
required. Set up the emulator only when “-.-.--.---“ is shown in (b) or the version
number of (b) is older than that of (c).
2. If the following error message is displayed, the host computer is not connected to the
emulator or the setup switch (SW1) is turned to ‘0’.
Figure 3.31 Error Message
If the setup switch (SW1) is turned to ‘0’, set it to ‘1’ and connect the USB cable again.
3. Click the [Setup] button.
When the following dialog box is displayed, turn the setup switch (SW1) to ‘0’, connect the
USB cable again, and click the [OK] button.
Figure 3.32 [License tool for H8S E10A-USB Emulator] Dialog Box
4. Setting up the emulator’s control software is started.