User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 54 of 292
Aug 10, 2012
(2) Setting up the emulator
1. Open the sliding switch cover and check that the switch (SW1) for setting the emulator is
turned to ‘1’.
2. Select [Renesas] -> [License tool for E10A-USB] -> [H8S Device Group] from [Programs] in
the [Start] menu. This starts up the license tool to add a device group to the emulator.
Figure 3.29 [Start] Menu
Figure 3.30 License Tool for Emulator
(a) Device group of the emulator firmware: Name of the device group currently set.
(b) Version number of the emulator firmware: The version number of software for controlling
the H8S Device Group in the emulator. This item
is displayed only when the H8S Device Group is
available.
(c) Version number of the setup program: The version number of the setup program.