User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 52 of 292
Aug 10, 2012
5. When the following dialog box is displayed, setting up the emulator is completed.
Figure 3.27 Message for Completion of Setting up the Emulator
6. When setting up the emulator has been completed, the following message will be displayed.
Turn the setup switch (SW1) to ‘1’, connect the USB cable again, and click the [OK] button.
Figure 3.28 [Setup Tool for SHxxxx E10A-USB Emulator] Dialog Box
Notes: 1. Be sure to turn the setup switch (SW1) to ‘1’ except when the setup tool is used.
2. To use the license tool for another device group, it is necessary to set up the firmware
by using the setup tool or license tool that corresponds to the device group. To use the
setup tool, however, the license tool must also be installed. For details on the license
tool, refer to the following section.