User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 51 of 292
Aug 10, 2012
4. Turn the setup switch (SW1) to ‘0’, connect the USB cable again, and click the [OK] button.
Setting up the emulator’s firmware is started.
Notes: 1. If the following dialog message is displayed, insert the USB cable again.
Figure 3.25 [Setup tool for SHxxxx E10A-USB Emulator] Dialog Box
2. When [Add New Hardware Wizard] is displayed, select [Install the software
automatically].
3. Although a dialog box will be displayed to indicate disconnection of the USB, this is
not a problem.
CAUTION
Do not turn off the host computer or disconnect the USB
cable while setting up the emulator. The emulator may be
damaged.
Figure 3.26 Start of Setting up the Emulator