User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 50 of 292
Aug 10, 2012
Notes: 1. If the version numbers shown in (b) and (c) are the same, setup of the emulator is not
required. Setup the emulator only when “-.-.--.---“ is shown in (b) or the version
number of (b) is older than that of (c).
2. If an emulator other than the SHxxxx E10A-USB is connected, the following error
message will be displayed to exit the setup tool.
Figure 3.22 Error Message
3. If the following error message is displayed, the host computer is not connected to the
emulator or the setup switch (SW1) is turned to ‘0’.
Figure 3.23 Error Message
If the setup switch (SW1) is turned to ‘0’, set it to ‘1’ and connect the USB cable again.
3. Clicking the [Setup] button displays the following dialog box.
Figure 3.24 [Setup tool for SHxxxx E10A-USB Emulator] Dialog Box