User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 48 of 292
Aug 10, 2012
3.10.1 Setting up at Purchasing the Emulator or Updating the Version of Software
Note: If you are using the HS0005KCU01H (serial No.: 03311C or later) or HS0005KCU02H
(serial No.: 04146E or later) emulator hardware, the below procedure may not be required;
follow the procedure only when the dialog box shown in figure 3.18 or 3.19 is displayed
by using the procedure described in section 3.11, System Check.
Figure 3.18 [The product currently connected] Dialog Box
Figure 3.19 [The version of the emulator firmware is incorrect] Dialog Box
1. Open the sliding switch cover and check that the switch (SW1) for setting the emulator is
turned to ‘1’.
2. Select [Renesas] -> [High-performance Embedded Workshop] -> [Tools] -> [Setup tool for
E10A-USB Emulator] -> [SHxxxx Device Group] from [Programs] in the [Start] menu. A tool
for setting up the emulator is activated.