User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 47 of 292
Aug 10, 2012
3.10 Setting up the Emulator
Set up the emulator’s firmware using the following procedures.
Note: Only one device group can be set up using the setup tool when the emulator is purchased.
Be sure to check the device group you have selected on the label for product management
attached to the back of the emulator box. To use the emulator for another device group
after set up, purchase the license tool to add a device group.
CAUTION
Do not disconnect the USB cable unless instructed to do
so by an on-screen message. Incorrect operation will damage
the emulator product.