User`s manual

SuperH Family E10A-USB Emulator Section 3 Preparation before Use
R20UT0870EJ1000 Rev. 10.00 Page 39 of 292
Aug 10, 2012
Table 3.5 Switch Settings of the E10A-USB (Using SH-3/SH-4 Series 36-pin Interface)
Switch Settings State of the E10A-USB
SW1 SW2 SW3
User-
interface I/O
Voltage
Signal to be
Connected
to Pin 15
Signal to be
Connected
to Pin 29 Condition
0 (off) - - - - - The emulator is
only set up
1 (on) 0 (off) 1 (on) 3.3 V fixed N.C. N.C. UVCC is
disconnected
1 (on) 1 (on) 1.8 V to 5.0 V N.C. UVCC Power is supplied
to UVCC
Table 3.6 Switch Settings of the E10A-USB (Using New_SH-Mobile Series/ SH-4A Series
Products with 4-bit AUD Bus Width/SH-2A Series 36-pin Interface)
Switch Settings State of the E10A-USB
SW1 SW2 SW3
User-
interface I/O
Voltage
Signal to be
Connected
to Pin 15
Signal to be
Connected
to Pin 29 Condition
0 (off) - - - - - The emulator is
only set up
1 (on) 1 (on) 1 (on) 1.8 V to 5.0 V N.C. UVCC Normally used
Table 3.7 Switch Settings of the E10A-USB (Using SH-4A Series 36-pin Interface for
Products with 8-bit AUD Bus Width)
Switch Settings State of the E10A-USB
SW1 SW2 SW3
User-
interface I/O
Voltage
Signal to be
Connected
to Pin 15
Signal to be
Connected
to Pin 29 Condition
0 (off) - - - - - The emulator is
only set up
1 (on) 1 (on) 1 (on) 3.3 V fixed AUDATA5 AUDATA6 Normally used