User`s manual

SuperH Family E10A-USB Emulator Appendix D Notes on High-performance Embedded Workshop
R20UT0870EJ1000 Rev. 10.00 Page 279 of 292
Aug 10, 2012
20. MCU for use in debugging
However, an actual MCU which has been used in connection with the E10A-USB Emulator
for debugging will have been programmed at emulation and subjected to stress accordingly.
Do not use an MCU that has been used for debugging in a mass-produced product.
21. Writing Flash Memory Mode
This mode is only intended for writing a user program to the internal flash memory. In this
mode, do not attempt anything other than downloading. When microcomputers are to be
continuously programmed, be sure to turn the target on or off.
22. Memory Access in the Writing Flash Memory Mode
Memory cannot be accessed in the Writing Flash Memory mode. In this mode, values
displayed in the [Memory] or [IO] window are dummy.
23. Memory Access during Flash Memory Programming
During flash memory programming (e.g., user program execution), operation for memory
accessing such as opening the [Memory] window is not allowed. Values displayed here are
dummy. Access the memory again after flash memory programming has been completed.
24. Host Computer in the Sleep or Hibernating Mode
The host computer must not enter the sleep or hibernating mode while the emulator is in use:
otherwise the emulator will not be operable. In such a case, re-connect the emulator after the
host computer has left the sleep or hibernating mode.
25. Manual Navigator
Follow the procedure below to execute this program under Windows Vista

or Windows
®
7.
Work-around:
(1) Log in with administrative rights.
(2) Open the properties window for file man_navi.exe in the Manuals folder under the
installation folder for the High-performance Embedded Workshop.
(3) On the [Compatibility] tabbed page, check the [Run this program as an administrator]
box.