User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 257 of 292
Aug 10, 2012
Table 6.4 shows the options for the [Loading flash memory] page.
Table 6.4 [Loading flash memory] Page Options
Option Description
[Loading flash memory]
radio button
Sets Enable for flash memory downloading.
When Enable is selected, and [File load] is selected from the [File]
menu for downloading, the write module is always called.
Enable: Download to the flash memory
Disable: Not download to the flash memory
[Erasing flash memory]
radio button
Sets Enable for erasing before the flash memory is programmed.
When Enable is selected, the erase module is called before calling
the write module.
Enable: Erase the flash memory
Disable: Not erase the flash memory
[File name] edit box Sets the file name of the S-type load module including the write and
erase modules. The file that has been set is loaded to the RAM
area before loading to the flash memory.
A maximum of 128 characters can be input for the file name.
[Bus width of flash
memory] list box
Sets the bus width of the flash memory.
[Flash memory erasing
time] edit box*
Sets the TIMEOUT value for erasing the flash memory. Set a larger
value if erasing requires much time; the default time is three
minutes. The radix for the input value is decimal. It becomes
hexadecimal by adding H’.
[Entry point] group box Sets the calling destination address or access size of the write and
erase modules.
[All erasing module address] edit box: Inputs the calling destination
address of the erase module.
[Writing module address] edit box: Inputs the calling destination
address of the write module.
[Access size] combo box: Selects the access size of the RAM area
where the write/erase module is loaded.
Note: Although the values that can be set are D'1 to D'65535, the TIMEOUT period may be
extended according to the set value. Therefore, it is recommended to input the minimum
value by considering the erasing time of the flash memory in use.