User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 252 of 292
Aug 10, 2012
Figure 6.61 [Editor] Window (PC Breakpoint Setting)
 Set the same program counter and stack pointer values (PC = H’00000800 and R15 =
H’00010000) as were set in section 6.8, Setting Registers (again, use the [Register] window).
Click the [Go] button.
When using the MCU with flash memory, specify the end address of the internal RAM for the
stack pointer (SP). The internal RAM area differs depending on the MCU. Refer to the
hardware manual of the MCU used.
 If program execution is failed, reset the device and execute again the procedures above.