User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 249 of 292
Aug 10, 2012
Figure 6.58 [Select Data] Page
 Open the [Select Data] page and select an option as the data to be measured. Select [Option 1]
in this example.
 Open the [Condition] page and specify the type of data to be measured. To measure the
number of elapsed cycles, deselect the [Disable] checkbox and select the [Cycle] checkbox on
the [Condition] page. Then select the [Elapsed cycles] checkbox on the [Cycle] page.
 After the data has been selected, press the [OK] button.