User`s manual

SuperH Family E10A-USB Emulator Section 2 Emulator Functions
R20UT0870EJ1000 Rev. 10.00 Page 8 of 292
Aug 10, 2012
Table 2.1 Emulator Functions (cont)
No. Item Function
5 Performance
measurement function
 Uses a counter in the device to measure the number of
cycles that passes during point-to-point execution.
 Measures the number of cycles that pass in executing
individual functions and lists them at the end of execution
from a ‘Go’ command.
6 Memory access functions  Downloading to RAM
 Downloading to flash memory
 Single-line assembly
 Reverse assembly (disassembly)
 Reading of memory
 Writing to memory
 Automatic updating of a display of selected variables during
user program execution
 Fill
 Search
 Move
 Copy
 Monitor (physical address)
7 General/control register
access function
Reads or writes the general/control registers.
8 Internal I/O register
access function
Reads or writes the internal I/O registers.*
9 Source-level debugging
function
Various source-level debugging functions.
10 Command line function Supports command input.
Batch processing is enabled when a file is created by arranging
commands in input order.
11 Help function Describes the usage of each function or command syntax input
from the command line window.
Note: The [IO] window displays the contents defined in [SHxxxx.io]. Editing those contents adds
or deletes the registers to be displayed. For the contents to be described as [SHxxxx.io],
refer to reference 6, I/O File Format, in the High-performance Embedded Workshop V.4.09
User’s Manual.
The following directory contains [SHxxxx.io] (xxxx means the name of emulator device
group.):
<High-performance Embedded Workshop folder>:
\Tools\Renesas\DebugComp\Platform\E10A-USB\xxxx\IOFiles