User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 239 of 292
Aug 10, 2012
(2) Displaying the trace result
 Set the start and end addresses, which are in the memory range that outputs the trace result, in
the [Start Address] and [End Address] edit boxes of [User Memory area], respectively.
 Enter the addresses depending on your environment. Do not specify the range that the
program has been downloaded to, as the memory contents are overwritten by the trace output
result.
 Run the program as shown in the example in section 6.17.1, PC Break Function. The trace
results are displayed in the [Trace] window after program execution is completed.
The following is an example of the trace display.
Figure 6.50 [Trace] Window (Example)