User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 225 of 292
Aug 10, 2012
When the setting is completed, the [Event] window will be as shown in figure 6.41.
Figure 6.41 [Event condition] Page
Note: The items that can be displayed in this dialog box differ according to the product. For the
items that can be displayed, refer to the online help.
 Set the program counter and stack pointer values (PC = H’00000800 and R15 = H’00010000)
that were set in section 6.8, Setting Registers, in the [Register] window. Click the [Go] button.
When using the MCU with flash memory, specify the end address of the internal RAM for the
stack pointer (SP). The internal RAM area differs depending on the MCU. Refer to the
hardware manual of the MCU used.
 If program execution is failed, reset the device and execute again the procedures above.