User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 220 of 292
Aug 10, 2012
 Click the [OK] button.
 The first point display in the State line changes from Disable to Enable.
 The first point display in the Condition line changes from None to Address =
H’00001068 (tutorial.cpp/45) pcafter.
 Set the program counter and stack pointer values (PC = H’00000800 and R15 = H’00010000)
that were set in section 6.8, Setting Registers, in the [Register] window. Click the [Go] button.
When using the MCU with flash memory, specify the end address of the internal RAM for the
stack pointer (SP). The internal RAM area differs depending on the MCU. Refer to the
hardware manual of the MCU used.
 If program execution is failed, reset the device and execute again the procedures above.
The program runs and then stops at the condition specified under Ch1(IA_OA).