User`s manual

SuperH Family E10A-USB Emulator Section 6 Tutorial
R20UT0870EJ1000 Rev. 10.00 Page 214 of 292
Aug 10, 2012
The PC breakpoint that has been set is displayed in the [Event] window.
Figure 6.33 [Event] Window (PC Breakpoint Setting)
Note: The items that can be displayed in this window differ according to the product. For the
items that can be displayed, refer to the online help.
To stop the tutorial program at the PC breakpoint, the following procedure must be executed:
 Set the program counter and stack pointer values (PC = H’00000800 and R15 = H’00010000)
that were set in section 6.8, Setting Registers, in the [Register] window. Click the [Go] button.
When using the MCU with flash memory, specify the end address of the internal RAM for the
stack pointer (SP). The internal RAM area differs depending on the MCU. Refer to the
hardware manual of the MCU used.
 If program execution is failed, reset the device and execute again the procedures above.