User`s manual

SuperH Family E10A-USB Emulator Section 1 Overview
R20UT0870EJ1000 Rev. 10.00 Page 5 of 292
Aug 10, 2012
Table 1.2 lists the acceptable operating environments.
Table 1.2 Operating Environments
Item 32-Bit Editions of Windows
®
XP 32-Bit Editions of Windows
Vista
®
or 32-Bit or 64-Bit
Editions of Windows
®
7
Host computer Built-in Pentium
®
III or higher-performance CPU (1 GHz or higher
recommended); IBM PC or compatible machine with USB 1.1/2.0 (Full-
Speed).
CPU Pentium
®
III (1 GHz) or higher
recommended
Pentium
®
4 (3 GHz), Core 2 Duo
(1 GHz), or higher recommended
Minimum memory
capacity
1 Gbyte or more recommended
(at least 10 times the size of the
load module file)
1.5 Gbyte or more recommended
(at least 10 times the size of the
load module file)
Hard-disk capacity Installation disk capacity: 600 Mbytes or more. (Prepare an area at
least double the memory capacity (four-times or more recommended)
as the swap area.)
Pointing device such as
mouse
Connectable to the host computer; compatible with Windows
®
XP,
Windows Vista
®
, or Windows
®
7
Display Monitor resolution: 1024 x 768 or higher
Power voltage 5.0 ± 0.25 V (USB-bus power type)
Current consumption HS0005KCU01H: 260 mA (max.)
HS0005KCU02H: 420 mA (max.)
CD-ROM drive Required to install the High-performance Embedded Workshop for the
emulator or refer to the emulator user’s manual.
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of
Microsoft Corporation in the United States and or other countries. All other brand and product
names are trademarks, registered trademarks or service marks of their respective holders.
1.3 Components
Check that all of the components are present when unpacking the product. For details on the
emulator components, refer to section 1.1 in the additional document, Supplementary Information
on Using the SHxxxx. If all of the components are not present, contact your nearest Renesas sales
office.